Caliper Mounting Bolts

Caliper Mounting Bolts

Most caliper mounting bolts and bracket bolts do not require special steps or torquing procedures to install. Typically, most caliper mounting bolts will be between 15 and 50ft. lbs. Thought that is true for many bolts, there are, in fact, other bolts that will require a process to correctly tighten.

Some mounting bolts require specific steps when tightening. Failure to follow these steps can cause the bolts to come loose. As a result, wheel damage and potential safety problems can occur if the caliper locks the wheel up.

The best possible practice is to follow the torque specifications whenever tightening mounting bolts. In the real world, this is not possible. Here are some guidelines when working with caliper mounting bolts:

Caliper Mounting Bolt Tightening Steps

  • Check the mounting bolt threads for signs of Loctite. (See Figure 39.1) If threads show signs of Loctite, the threads should be cleaned, and a new Loctite should be applied. Torque the bolts to the manufacturer’s specifications.
Bolts with Loctite

NOTE: Some manufacturers state bolt replacement is necessary.
  • The larger the mounting bolt, the higher the required torque. Some of these bolts, such as those pictured in Figure 39.2, need tightening torques over 100 ft. lbs. On larger mounting bolts, you must tighten the bolts correctly.

More Tips and Tricks

Looking for more tips? Consider joining our Facebook group "Mechanic Mafia" or check out some of our other articles below:

Facebook Group

More Articles
Back to blog

Leave a comment

Other Blog Categories